GOK SmartBox 4 - Page 22

SmartBox
®
4 / SmartBox
®
4 PRO
22 / 28 part no. 28 400 57 d
Comm-
and
Parameter
Description
Standard /
default value
#T=
Mobile network
number for the
SMS
messages
Mobile phone number to which the
automatically generated reporting SMS are
sent (e.g. building supervisor, headquarters)
#TA1=
(identic
al to
#TA=)
1. Mobile
phone number
for alarms
1. Mobile phone number for a fault mobile
phone. If for #TA1=... an alarm number is
entered, the alarm SMS is sent to this number
(approx. 5-minute delay).
If no number is entered (field empty), the
report is sent to the #T number.
If Smart-
Inspector
connection
exists, this
field is empty
#TA2=
…
#TA3=
2. + 3. Mobile
phone number
for alarms
2. + 3. Mobile phone number for a fault
mobile phone. The current alarm is reported to
this number as 2. / 3. (for delay time, see
command #Q= ) If this alarm number is not
entered (empty), this means that the end of the
alarm chain has been reached and that there
are no further messages for this alarm.
If Smart-
Inspector
connection
exists, this
field is empty
#Q=
Change the delay time for the alarm chain, e.g.
#Q=10 sets the delay time to 10 minutes.
20
[1…255]
#H=
Text 0 – 40
signs max.
Header-Text, introducing every SMS
message.
Tank
monitoring
#P=
10,30,15,07
(always enter
4 values as 2-
digit figures,
preceded by 0
if necessary!)
Fill level message points:
[from..to]
Number
1 =
Percentage increment for new
message, e.g. report fill level after
every 10%.
10,
[01..99] %
Number
2 =
Period of days for new message,
e.g. send a report on the system
min. every 30 days. Or indicate
number of hours with xxh. Add ‘h’
to indicate a number of hours.
30,
[01..99] Tg
[01h..24h]
Number
3 =
’Critical limit value’ in per cent, i.e.
if the value falls below the limit, an
alarm message is sent.
15,
[00..99] %
Number
4 =
Interval of days for repeating the
message on limit value.
07,
[01..31] days
[01h.24h]
5. Value:
10,30,15,07,
0,5,0
Number
5 =
0 Triggers a limit value report as
soon as one of the tanks reaches
the reserve level.
1 Triggers a limit value report only
when all of the tanks reach the
maximum level.
2 Triggers a limit value report as
soon as one of the tanks reaches
the reserve level.
3 Triggers a limit value report only
when all of the tanks reach the
maximum level.
0
[0 to 3]