Buzzaround_SG_REVA_040711
18
DRIVE WHEEL REPLACEMENT
To replace the drive wheel:
1) Place the freewheel lever in the engaged position.
2) Remove the key from the key switch.
3) Place a support under the scooter frame to raise the drive wheel.
4) Remove the hubcap.
5) Remove the nut and washer that fastens the drive wheel to the axle. See figure 4.
6) Remove the drive wheel from the axle. Retain the axle key.
7) Place a new wheel onto the axle. Make sure the axle key is installed properly.
8) Reinstall the nut and washer and tighten securely.
8) Reinstall the hubcap.
Figure 4. Drive Wheel
AXLE KEY
DRIVE WHEEL
DRIVE WHEEL NUT
To Next Page
Loading...
