golmar Art 7/G2+ - Door Panel Call Screen Operations; Call Status and Duration; Access Image Settings During Call; Change Image Source

15
DOOR PANEL CALL SCREEN
ART 7T/G2+ MONITOR
This screen is displayed when you receive a call or when you press the button below icon of the main menu.
During a call, icon displayed on the screen green (during the call process). In the top centre of thecolor
screen, the date and time are shown and, on the , the source of the image is displayed (door panel 1 doorleft to
panel , camera 1 camera ). The call has a duration of 45 seconds4 to 4
.
Only if you have pressed the hidden button below the icon in the main menu (see page 6), the icon will
appear on the screen, to end the current display and return to the main menu.
Press the button below icon to start audio communication with the door panel displayed or (you can
also lift the handset).
Press the hidden button below icon to change the source of the image as long as the system has
more than one door panel or has an external camera connected and display has been activated (see
pp. 2 - ). It is possible to make the change during display, call and communication processes8 31 .
A few seconds after receiving a call, it automatically takes a photograph. In the top of the screen,right
icon is displayed and indicator will illuminate. Press the hidden button below icon to take a
picture.
If a Micro SD card is inserted, a 15-second video automatically starts recording a few seconds after
receiving the call. In the top of the screen, icon is displayed and indicator will illuminateright
(see p. to configure video recording mode). Then a short 1-second press on the hidden button10
below icon will take a photograph or a long -second press will record a video.3
Press the button below icon to activate the lock release (or device connected to the CV output of the
door panel) for 3 seconds(factory setting, programmable by the installer; see pp. 2 - . During8 31)
activation, indicator will illuminate.
Press the hidden button below icon to activate the lock release (or device connected to the relay output
of the door panel) for 3 seconds (factory setting, programmable by the installer; see pp. 2 - . During8 31)
activation, indicator will illuminate.
1
2
1
2
2
Press the button below icon for 3 seconds to access the image settings menu during the call process.
Select the option to be modified by pressing the button below correspondinghiddeen /button
icons / , change to the desired level by pressing the buttons below corresponding icons /
and validate the changes made by pressing the button below icon , (see pages 17 to 18).
Press the hidden button below icon to end the call tone on the monitor.
1 2
1
23-09-2023 18:25