15
When the channel required is shown use the volume +/- keys on the remote or the
front panel of the amplifier component to adjust the volume of the selected
channel.
4.4 Mute
To mute the audio output press the MUTE button and the sound from the
speakers will be turned off with display “MUTE ON” on the screen of Tuner. To
restore previous audio output press the mute button again.
4.5 Virtual Surround Sound (For DVB-T only)
When listening to a two channel source press the DVB-T SURROUND(DSP)
button on the remote control or the front panel to process the source using virtual
surround sound. When this is selected sound will be heard from all 5 speakers
plus the subwoofer. When virtual surround is enabled “SUR ON” will be briefly
shown on the display and “DSP” will be remaining in the display.
4.6 Treble
To adjust the treble output of the sound use the TREBLE +/- buttons on the front
panel. The positive numbers indicate that the treble output is enhanced and
negative numbers indicate that the treble output is attenuated. For example +10
indicates the treble is fully enhanced and –10 indicates the treble is attenuated to
a maximum.
4.7 Bass
To adjust the bass output of the sound use the BASS +/- buttons on the front
panel. The positive numbers indicate that the bass output is enhanced and
negative numbers indicate that the bass output is attenuated. For example +10
indicates the bass is fully enhanced and –10 indicates the bass is attenuated to a
maximum.
4.8 Default Tone Settings
Press the TONE RESET button on the front panel to return the tone settings to the
default settings. “TONE RS” will be shown briefly on the display.
4. Basic Setup (cont)
To Next Page
Loading...
