35
9.1. Over Air Download
Over Air Download: To ensure that your digital receiver always has the most up to
date information. Please ensure that after use it is set to its standby mode. The
DVB-T automatically powers up at 3AM each day and searches for any new
information which may be broadcast and will download this to your box
automatically. This operation will normally take approximately 30 seconds.
If you have an important recording to make at 3AM which must not have a 30
second interrupt then you can disable the auto OAD search by performing the
following:
1. Press Menu button and using the up / down buttons highlight SETTING and
press the SELECT button, using the up / down buttons highlight CONFIG and
press the SELECT button.
2. Use the up and down buttons to highlight "RECEIVER UPGRADE" and press
SELECT button.
3. Using the left / right button change function from Enable to Disable.
4. Press SELECT button then MENU and MENU to return to Normal l operation.
Do not forget to re enable the automatic OAD function after you have made your
recording by repeating the above instructions but this time selecting ENABLE.
9.2. Switching On
Turn on your TV set and select the SCART input (with the AV key, or similar, on
the television remote control). Turn on the mains supply to the DVB-T receiver
(the receiver's menu will be seen on the TV screen.)
If after connecting the DVB-T to your TV as shown and you do not see a picture,
press AV button on your TV remote until you see the “First Time Install” screen.
If you do not see the receiver's menu on the television screen, refer to the
Troubleshooting Guide.
9.3. Tuning In
Because this is the first time that the receiver has been used, there are no
channels stored in the receiver's memory and the First Time Installation menu is
displayed on the screen.
9. DVB-T Operation
To Next Page
Loading...
