EasyManua.ls Logo

Gorilla 47027 Greyback - Double Check; Practice and Test

Gorilla 47027 Greyback
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18
Once the climbing treestand is attached at ground level, use the full
body harness according to the manufacturers instructions.
To purchase an additional full body harness or to nd out more
information regarding full body harnesses, please contact the nearest
Gorilla dealer or call Gorilla at 877-685-7817.
Double Check
Fall hazard.
An unsecured D-ring can result in a fall.
D-ring snap pins MUST be installed through
top of adjustment arm and through tree cable.
D-ring snap pin MUST be securely engaged.
Always inspect before each use.
Failure to follow these instructions can result in
serious injury or death.
A good non-slip boot is important for your safety. Be especially careful
that bootlaces do not get hooked on the climbing treestand
(tuck shoelaces into boot before climbing).
Before stepping on the platform, always double check to make sure
all the D-ring snap pins are attached from the top of the adjustment
arm and are locked in place with the spring portion of the pin secured
in the groove on the pin.
Make sure that the D-ring snap pin has engaged the cable end of
the tree cable. Apply downward pressure to the front of both the
platform section and the seat section of the climbing treestand prior to
climbing. If the D-ring snap pin is not engaged, the section will slip.
Check your full body harness again to ensure that it is properly
attached to you and to the tree. Always remain connected to the tree.
Never disconnect your full body harness from you or the tree after
leaving the ground.
Make sure platform section and seat section are attached with the
tether to prevent separation while in use.
Practice and Test
Become familiar with the treestand design and features. Always practice
installing, detaching, adjusting, and using your treestand at ground level
prior to using in a hunting environment or at elevated positions.
Also, practice at ground level in low light conditions as these conditions
may exist while hunting.
You should test the operation of your climbing treestand at ground level
before hunting. Testing at ground level should occur at the rst use of
each season and after long periods of storage.
9
8
WARNING

Table of Contents

Related product manuals