Gorilla 47027 Greyback - Attach Seat Section to Tree

14
Fall hazard.
D-RING SNAP PINS MUST BE INSERTED
THROUGH TOP OF ADJUSTMENT ARM AND
THROUGH TREE CABLE.
D-ring snap pins MUST be locked into
pin groove.
Failure to follow these instructions could
cause pin to dislodge and lead to serious injury
or death.
Attach Seat Section to Tree
Place the seat section of the climbing treestand approximately
12-18 inches above the platform section of the climbing treestand
(FIGURE 18).
The seat section installs the same way using a cable assembly and two
D-rings as the platform section. Repeat steps 4.1 through 4.4 on how to
prepare platform section.
When you have completed steps 4.1 through 4.4, the climbing treestand
should look like FIGURE 19.
Fall hazard.
D-RING SNAP PINS MUST BE INSERTED
THROUGH TOP OF ADJUSTMENT ARM AND
THROUGH TREE CABLE.
D-ring snap pins MUST be locked into
pin groove.
Failure to follow these instructions could
cause pin to dislodge and lead to serious injury
or death.
WARNING
WARNING
5
FIGURE 18 FIGURE 19