23
Sit on the climbing bar and with your feet, tip the platform section
forward (FIGURE 36) and lift up the platform section by lifting up your
legs approximately 8-12 inches.
Level the platform section by rotating your ankles so the platform teeth
dig back into the tree (FIGURE 37). Never jump or bounce on treestand
to seat/dig it into to the tree.
Stand up on the platform.
Adjust Harness’ Tree Strap and Raise Top Seat Section
Raise the harness’ tree strap higher up the tree according to the
harness manufacturer’s instructions (FIGURE 38). The tree strap should
be positioned at the standing height you noted in step 10.4 so that it
is properly positioned when you are sitting. Always maintain the least
amount of slack in tether that will allow for climbing.
Lift up the top seat section (FIGURE 39) until the tether connecting the
seat section to the platform becomes tight. See section 5.1 for proper
tether length.
Sit down on the climbing bar on the top seat section (FIGURE 40) so
you can lift the platform section with your legs again
as in step 10.7.
FIGURE 37
10.8
Tree strap
Tether
FIGURE 38 FIGURE 40FIGURE 39
To Next Page
Loading...