GOSSEN METRAWATT GMBH 13
Electrical Connection
Connectors: Screw terminals for wire with a cross section of 1.5 square mm or
two-core wire-end ferrules with a cross-section of 2 x 0.75 square mm
Tighten screws with a manual screwdriver only! Tightening torque for all screw terminals: max. 0.6 Nm
EN 55022 requires the following warning as regards electromagnetic compatibility:
Performance After Activating Auxiliary Voltage
Warning
This is a class A device. It may cause radio interference in residential surroundings. If this is the
case, the operator may be required to implement appropriate corrective measures.
U/M Software Version
Current Configuration
LED Segment Test
approx. 2 s
approx. 1.5 s
CnF1
Actual Value
Setpoint or oFF
approx. 1.5 s
Current
Configuration
Hardware Designation
G Designation
CnF2
To Next Page
Loading...