22 GOSSEN METRAWATT GMBH
Alarms
The display is switched to the operating level 30 seconds after value selection has been completed during con-
figuration or parameter setting.
Error Messages
Responses in the event of an error:
1. In the case of R2100 G1 alarm output A1 is activated; output performance is determined by the “alarm 1”
configuration digit (see Configuration on page 25).
In the case of other controllers and designations and in the case of configuration as a 2-step controller,
read-out takes place at switching output II. LED II lights up when the relay contact II is closed and/or
transistor output II is active.
2. LED A1 blinks at all levels. The (blinking) error message only appears at the operating level: in the event of
faulty measured values at the display, at which the error-free measured value is otherwise displayed (SE H,
SE L and CE) while other error messages appear in the upper display.
3. The display is switched to the operating level 30 seconds after value selection has been completed during
configuration or parameter setting.
4. Exceptions and additional information are included in the following table:
Blinking Display Error Message Source Blinking
Display
Output Comment
Heating current Heating current monitoring LED A1 Output A1 activated
1)
or output II activated
2)
1)
only for R2100 G1
2)
only in the case of configuration as a 2-step controller
NO / NC contact defines in config-
uration digits “alarms 1 and 2”
LED blinks at all levels
Actual value Limit value monitoring 1 LED A1 Output A1 activated
1)
or output II activated
2)
Actual value Limit value monitoring 2 LED A2 Output A2 activated
1)
To Next Page
Loading...
