Gossen MetraWatt R2080 - Mechanical Installation; Preparation

8 GOSSEN METRAWATT GMBH
Mechanical Installation / Preparation
The RXX0 controller is intended for installa-
tion to a control panel. The installation lo-
cation should be vibration-free to the
greatest possible extent. Aggressive vapors
shorten the service life of the controller.
Requirements set forth in VDE 0100 must
be observed during the performance of all
work. Work on the device may only be car-
ried out by trained personnel who are fa-
miliar with the dangers involved.
Set the housing into the panel cutout from
the front, and secure it from behind at the
left and right-hand sides with the two in-
cluded screw clamps.
Push the screw clamps first all the way up
to the limit stop in direction 1 and subse-
quently in direction 2 for this purpose.
Typical tightening torque amounts to
10 Ncm, and a value of 20 Ncm should not
be exceeded.
In general, unobstructed air circulation
must be assured when one or several de-
vices are installed. The ambient tempera-
ture underneath the devices may not ex-
ceed 50 °C.
5
96
96
50
R2080, R2180 and R2100 G0
R2100 G1 only
92
+0,8
92
+0,8
Panel cutout
1
2
1
2
70
5