Gossen MetraWatt R2600 - Configuring the Switching Outputs I and II; Behavior When the Auxiliary Voltage Is Switched on

GOSSEN-METRAWATT GMBH 12
Configuring the switching outputs I and II
Behavior when the auxiliary voltage is switched on
With marking A3 and the use of a transistorized output, the continuous output must only be used as 10 V output (load ≥ 10 kΩ).
12345
12345
12345
12345
Relay
Transistorized output
Switching output I Switching Output II
Relay
Transistorized output
Actual value
Set point or oFF
Unit of measure Software version
Actual configuration
LED segment test
ca. 2 s ca. 1,5 s
ca. 1,5 s
Actual configuration
CnF2
A marking B marking
CnF1