GOSSEN-METRAWATT GMBH 4
Safety features and safety precautions
The R2600 / R2601 controller is constructed and tested in compliance with the safety rules of IEC 1010-1 / VDE 0411-1.
When properly used, the safety of both the user and the unit is assured.
Read the operating instructions carefully and completely before you use your unit. Follow them in all respects.
Make the operating instructions accessible to all users.
Please note the following safety precautions:
– The controller must only be connected to a line corresponding to the nominal range of use (see connection diagram and nameplate) which is fused
for a maximum nominal current of 16 A.
– A switch or a power switch must be provided in the installation as isolating device.
The controller must not be used:
– When the exterior shows obvious signs of damage
– When it no longer functions correctly
– After prolonged storage under adverse conditions (e.g. moisture, dust, temperature).
In such cases, take the controller out of service and secure it against accidental use.
To Next Page
Loading...
