Radiation Exposure Statement:
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
For Remote controller. SAR tests are conducted using standard operating
positions accepted by the FCC/ISEDC with the device transmitting at its highest
certified power level in all tested frequency bands. although the SAR is
determined at the highest certified power level, the actual SAR level of the
device while operating can be well below the maximum value.
Before a new model device is available for sale to the public, it must be tested
and certified to the FCC that it does not exceed the exposure limit established
by the FCC/ISEDC, Tests for each device are performed in positions and
locations (e.g. at the ear and worn on the body) as required by the FCC/ISEDC.
For body worn operation, this model device has been tested and meets the
FCC/ISEDC RF exposure guidelines when used with an accessory designated
for this product or when used with an accessory that Contains no metal and
that positions the handset a minimum of 10 mm from the body. Non-compli-
ance with the above restrictions may result in violation of RF exposure
guidelines.
MODEL G1 pro/G2 pro:
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: 1) This device may not
cause harmful interference, and 2) This device must accept any
interference received, including interference that may cause
undesired operation.
FCC Warnings: Replacement or substitution of transistors, regular
diodes or other parts of a unique nature. with parts other than
those recommended by Gowei may cause a violation of the
technical regulations of part 95 of the FCC rules, or violation of type
acceptance requirements of part 2 of the rules.
-22
To Next Page
Loading...