Ribbon & Paper installation diagram
Print head
Ribbon
Media guide
Platen roller
Gap/Black mark sensor
Media guide rod
Print head
LED Indicator:
*ON LINE
Cover-open button
FEED button
PAUSE button
LED indicator
Ethernet USB Serial Parallel Power port
Top cover
Paper roll
Ribbon take-up shaft
1.Press two buttons in left and right side
of top cover to lift and open the cover.
2.Insert the paper roll into the shaft as picture
showing, and fix the label roll in the middle.
3.Put paper roll into the printer.
4.Press the button to open print head
5.Pull out the paper, use the paper guide to fix the label in correct position till the
label pass gap sensor and rubber roller.
Ribbon Installation:
1.Insert the ribbon take-up shaft into
an empty roll.
2.Install ribbon take-up shaft and empty
roll into the printer, left side first, right
side afterwards.
3.Insert ribbon supply shaft into
new ribbon
4.Open print head by pressing the
picture showing button
5.Install ribbon supply shaft into the
printer, left side first, right side
afterwards.
6.Pull out ribbon and let it touch the
print head and roll onto the step 1
showing empty roll
7.Adjust the running wheel to let
the ribbon touch print head flat
8.Close the print head by pressing
mechanism two sides to make sure
print head is closed completely for
good quality printing
Remark:
GP-1124T 3 in 1 interface(Serial+USB+Parallel), without external paper holder
but with paper roll and ribbon.
GP-1125T 4 in 1 interface(Serial+USB+Ethernet+Parallel), with external paper
holder, paper roll and ribbon.
Note:The picture showing ports is for GP-1125T.
Paper guide
Paper guide rod
Gap/Black mark sensor
Rubber roller
*If you need more information about the product, please refer to the User’s Manual in CD.
*The printer specification, accessory, spare parts and program are subject to change
without prior notice.
Quick Installation Guide
GP-1124T/1125T Thermal Transfer Barcode Printer
Media
Ribbon core
Ribbon rewind hub
Outward rolling media
Inward rolling media
Label paper fixing stand
Push button for thermal
print head open
Paper Installation:
mechanism.
*ERROR
*RIBBON Status
Ribbon ta ke-up runn ing wheel
Externa l paper entr ance
To Next Page
Need help?
General
