Measure the thickness of the prongs.
Service limit: 4.7 mm
Inspect gear drum surfaces and grooves for
wear or damage
Inspection of main and
countershaft components
Check whether the gears of the main and
countershaft assemblies have excessive or
abnormal wear , and check whether the collars
between the gears are deformed or fallen off.
Inspection of oil filter parts and oil filter
1. Check the cleanliness of the oil filter parts
and oil filter screen; rinse the oil filter parts and
oil filter screen with poor cleanliness with clean
gasoline;
2. Check whether the oil filter parts and oil
filter are damaged; if there is damage, replace the
new oil filter parts and oil filter.
To Next Page
Loading...