How to Spray
18 3A5097C
Triggering Gun
Pull trigger after starting stroke. Release
trigger before end of strike. Gun must be
moving when trigger is pulled and released.
NOTE: To prevent uneven spray pattern,
start and end stroke off of work piece surface.
Aiming Gun
Aim center of spray gun at bottom edge of
previous stroke, overlapping each stroke by
half.
If gun does not spray, reference
Troubleshooting, page 24.
Refilling FlexLiner
1. Perform Pressure Relief Procedure,
page 8.
2. Reference Fill FlexLiner System, page
12.
Refilling Siphon Cup
1. Perform Pressure Relief Procedure,
page 8.
2. Reference Fill Siphon Cup, page 14.
ti30763a
To Next Page
Loading...
