Registering the Meter
313046A 5
Registering the Meter
Graco recommends registering the meter prior to
installation.
NOTE: Before registering the meter, use the Matrix PC
software to enter setup information pertaining to the:
• Transceiver,
• Tank Level Monitor (TLM),
• Tank Set Up,
and (optional)
• Pump Air Control (PAC).
If this has not been done first, the software will display
an error when attempting to set up meter.
Main Utility Setup Screens (FIG. 4)
The Main Utility Screen displays a list of available Setup
Screens. This list also includes a link (QUIT) back to the
Operation Screens.
•REGISTER
• RF TEST
•UPGRADE
•EMERGENCY
•QUIT
Displaying Register Utility Screen
1. If you are on a Dispense Screen, to display the Main
Utility Screen, first hold down the RIGHT ARROW
(a) only, for a few seconds (F
IG. 3).
2. Then at the same time, also hold down the center,
ENTER button (b) (F
IG. 3). Hold both buttons down
until the Main Utility Screen shown in F
IG. 4 dis-
plays.
3. Use the UP or DOWN arrow to move the cursor up
and down the list until it is over the REGISTER
option on the list.
4. Press the center ENTER button on meter’s keypad
to select the REGISTER option. The Register
Screen shown in F
IG. 5 displays.
F
IG. 3
(a)
(b)
ti11824a
FIG. 4
REGISTER
RF TEST
UPGRADE
EMERGENCY
QUIT
3.01.001
ti12259a
To Next Page
Loading...
