Troubleshooting
313046A 25
Error Codes
Error codes are listed below. Even in an error condition
the unit keeps track of the amount dispensed. With any
error code displayed you must end a dispense.
Error Code Cause Solution
Err 2
Switch Error: Error occurred with
pick-up in internal gear.
or
Ensure that your flow rate is not
higher than 14 gpm (37.8 lpm). For
further assistance, contact your
Graco distributor.
Unit was dropped or unit encountered
excessive vibration during shipping.
End Dispense
Err 4
Flow has continued after it should
have shut off.
or
End Dispense
Flow has occurred in lockout condi-
tion.
Err7
CAP ERROR: Error has occurred in
control.
Replace electronic bezel assembly.
Order Kit 255886.
To Next Page
Loading...
