Troubleshooting
24 313046A
Meter leaks from twist lock nozzle.
• It is important to distinguish
between the two causes of this
problem. A new nozzle will NOT
correct a fluid leak caused by a
faulty valve.
Twist lock nozzle has a damaged
seal.
Replace nozzle. See Step 1 in Instal-
lation Procedure, page 14.
Valve has damaged or obstructed
seals.
Clean valve stem o-rings.
Meter leaks from swivel.
Poor swivel/hose connection. Apply PTFE tape (leave a minimum 2
engaged threads uncovered for elec-
trical continuity) or sealant to threads
of hose and tighten the connection.
See Step 3 in Installation Procedure,
page 13.
Poor swivel/meter housing connec-
tion.
Torque the fitting to 20-25 ft.-lbs.
Swivel seals have deteriorated and
leak.
Replace swivel.
Unit does not stop dispensing when
assumed preset amount is dis-
pensed.
Valve is dirty or seals are defective. Clean valve or replace valve seal.
Low battery. Replace batteries, page 26.
Solenoid not functioning (Preset
only).
Replace solenoid.
Problem Cause Solution
To Next Page
Loading...
