Reassembly
309869C 27
15. Align the holes in the valve nuts
(24*) and the slots on the stems of
the poppet valves (32*) and install
the lock wires (25*) through the
holes in the top and bottom valve
nuts. For more detail see F
IG. 1,
page 36.
16. Pull the lock wires (25*) down
tightly, and bend the ends out with
pliers so that they cannot be
pulled back out of the holes.
17. Grease and install o-ring packing
(18*).
CAUTION
Never reuse the old lock wires. They
will get brittle and break easily from
too much bending.
To Next Page
Loading...
