Reinstalling the Fire-Ball Pump
34 309869C
Reinstalling the Fire-Ball Pump
Replacing the pump back into production.
Before remounting the pump, connect an air hose and run the air motor slowly, starting with just enough air
pressure to make the air motor run. Make sure that it operates smoothly.
1. Place the pump back into it’s mounting.
2. Reconnect any hoses
3. Reconnect the ground wire from the ground screw (14).
4. Pressurize the pump.
WARNING
Read warnings beginning on page 3. Never operate the pump with the warning
plates (47) or the identification plate (46) removed. These plates protect your fin-
gers from getting pinched or amputated by moving parts in the air motor.
To Next Page
Loading...
