Setup
3A9301C 11
Setup
Pressure Relief Procedure
1. Turn Prime Knob up to PRIME position
to relieve system pressure.
2. Hold metal tip guard nut firmly to a
grounded metal pail. Point Spray Gun
into pail, disengage Trigger Lock, and
trigger the Spray Gun to relieve system
pressure.
NOTE: Leave Prime Knob in the PRIME
position until you are ready to spray.
This sprayer builds up an internal
pressure of 2000 psi (138 bar, 14 MPa)
during use. Follow the Pressure Relief
Procedure whenever you stop spraying
and before cleaning, checking, servicing,
or transporting equipment to prevent
serious injury from pressurized fluid.
NOTICE
To avoid damage, never immerse the
electronic Spray Gun in water or other fluid.
To Next Page
Loading...
