Setup
12 3A9301C
Sprayer Setup
If spraying oil-based or flammable
materials, review Cleaning Fluid
Compatibility, page 26 and follow
Grounding Instructions, page 10.
NOTE: It is recommended to always
pre-strain the paint prior to filling the cup.
1. Engage Trigger Lock. Turn Prime Knob
up to PRIME position.
2. Remove Cup Lid from the Cup.
3. Verify a clean Pump Filter is installed in
the bottom of the Cup at the pump inlet.
Use the black, 60 mesh filter with paints
and the blue, 100 mesh filter with stains
and thin materials.
NOTE: A dirty or plugged Pump Filter will
result in poor sprayer operation or loss of
prime.
4. Fill Cup with paint and reinstall Cup Lid.
NOTE: Do NOT shake materials to be used
with this sprayer. Some fine finish lacquers
and enamels trap air when shaken, which
can affect sprayer performance. Stir the
material or check the manufacturer’s
recommendation for the material being
sprayed.
NOTE: Use of the Storage Plug on top of the
Cup Lid is optional. Storage Plug must be
open while spraying to avoid an air lock and
loss of prime.
Flammable fumes (such as solvent and
paint fumes) in work area can ignite or
explode.
See Grounding Instructions, page 10.
Do not spray flammable or combustible
liquids in a confined area. When spraying
flammable or combustible materials:
• Move entire sprayer to a
well-ventilated area and away from
flammable or combustible materials,
including paints and solvents when
refilling.
• Keep material containers covered
between Cup refills.
To Next Page
Loading...
