Spraying
20 3A9301C
Cup Refills
Cup refills can be performed while wearing
the sprayer on the Belt or after removing the
sprayer from the Belt and setting in on a flat
surface.
1. Engage Trigger Lock. Turn the Prime
Knob up to PRIME position to relieve
system pressure.
2. If desired, remove sprayer from the Belt
by pressing the Holster Release Clip and
pulling up on the sprayer.
3. Remove the Cup Lid from the Cup.
Flammable fumes (such as solvent and
paint fumes) in work area can ignite or
explode.
See Grounding Instructions, page 10.
Do not spray flammable or combustible
liquids in a confined area. When spraying
flammable or combustible materials:
• Move entire sprayer to a
well-ventilated area and away from
flammable or combustible materials,
including paints and solvents when
refilling.
• Keep material containers covered
between Cup refills.
To Next Page
Loading...
