Storage
3A9301C 25
Storage
Pump Armor fluid protects the sprayer while
in storage. It helps protect sprayer against
startup issues on next use.
Storage
•
Circulate and spray a small amount of
Pump Armor Storage Fluid.
• Engage Trigger Lock
• Turn Prime Knob to PRIME position.
• Remove Battery, Spray Tip and Spray
Tip Guard.
• Clean Spay Tip and Spray Tip Guard
with warm water and an old tooth brush,
and reinstall onto gun.
• Turn Spray Tip 90 degrees for storage,
and CLOSE Storage Plug on Cup Lid.
• Do not store the sprayer full of water.
• Do not allow water to freeze in sprayer.
• Do not store sprayer under pressure.
• Store sprayer indoors in a cool, dry
location.
• Never store sprayer with material in the
sprayer or Cup.
NOTICE
Failure to store sprayer with Pump Armor
can result in operational problems the next
time you spray. Always circulate Pump
Armor through the sprayer after cleaning.
Water or solvents other than mineral
spirits left in the sprayer will corrode
and damage the pump.
To Next Page
Loading...
