Startup
14 3A9301C
Startup
Always start with a fully charged Battery.
Do not splash or immerse Battery or
charger in water or solvents. See Battery
and charger information shipped with the
sprayer.
1. Disengage Trigger Lock and verify
Prime Knob is pointed up in the PRIME
position.
2. Turn the Spray Tip to UNCLOG position.
3. Install fully charged Battery onto
sprayer.
4. Verify Storage Plug is OPEN.
5. To prime the pump, point the Spray Gun
into a waste pail and pull the Trigger for
10 seconds. This will purge air from the
pump.
NOTE: The electronic Spray Gun is always
open when the Trigger is pulled so a small
amount of fluid may spray out while priming.
Replace and charge Battery only in a
well-ventilated area and away from
flammable or combustible materials,
including paints and solvents.
To Next Page
Loading...
