Setup
311075R 21
e. Turn on Motor Power.
f. Set Recirc/Spray valves to
Recirc.
g. Set function knob to Slow Recirc
or Fast Recirc .
OR
h. When clean fluids exit both recir-
culation tubes (P), set function
knob to Stop/Park .
i. Replace recirculation tubes in
supply tanks.
j. On nonheated units, purge the
hoses through the gun without a
static mixer installed.
For heated units, continue with Startup of
Heated Units, page 22.
Nonheated units are ready to spray/dis-
pense. Go to Spraying/Dispensing, page
25.
To Next Page
Loading...
