Setup
10 3A5384B
Setup
Charge Battery
If the battery is newly purchased or has not been used
for a long time, use a standard 12vdc automotive battery
charger to charge it before use.
Installation of RoadLazer into
Vehicle
RoadPak Installation
Load RoadPak into vehicle using a forklift or a hoist that
is rated for the weight capacity of the RoadPak. For
RoadPak weight information see Technical Data, page
32.
The RoadPak can be mounted in the front or rear of the
vehicle bed as well as in any orientation desired. The
base of the RoadPak is 39.5 in. x 49.5 in. (1.0m x
1.25m).
After mounting the RoadPak on the vehicle, firmly
secure the RoadPak to the vehicle using the tie-down
brackets at all four corners, or by bolting the RoadPak
through the bed of the truck to the frame in all four loca-
tions.
CRUSH HAZARD
RoadLazer needs to be properly secured to prevent it
from moving during transportation and operation.
Paint drums are heavy and could shift from side to
side when the vehicle is cornering. The paint drums
could fall from the vehicle and cause injury or death.
Secure the drums when the vehicle is in transport or
spraying.
To Next Page
Loading...
