Operation
26 3A5384B
13. Turn pressure control counterclockwise to lowest
pressure.
Start Engine
1. Set POWER ON/OFF on Programmable Skipline
Controller to ON.
2. Set engine choke to ON position (19 HP only).
3. Set throttle to half speed and turn key.
4. After engine starts, set choke to OFF (19 HP only).
Select/Prime Pumps
1. Turn the bypass valve to RUN and open hydraulic
valve(s) to activate pumps.
2. Slowly turn pressure control clockwise until pump
begins to stroke.
3. When flushing fluid comes out of return lines, set
hydraulic valve to OFF position.
To Next Page
Loading...
