Operation
3A5384B 31
Securing Gun Arm for
Transportation
NOTE: Never transport the RoadLazer while the paint gun
ball valves are open, the system is under pressure, and/or
the engine is running, as this could cause damage to com-
ponents.
1. Unlock red-handled clamp to allow gun arm to move
along slide beam.
2. Lift gun arm up from ground, and push in to center of
height adjustment bracket, and align it with the stow
bracket.
3. Pull gun arm hitch pin out of the stow bracket.
4. Slide the hitch pin through the gun arm bracket and
stow bracket. Insert clip through pin.
5. Unlock two red-handled clamps and center the slide
beam on the vehicle.
6. Lock three red-handle clamps to secure the slide beam
and gun arm.
To Next Page
Loading...
