Operation
30 3A5384B
13. Only open spray gun ball valves corresponding to
paint pumps or color used.
NOTE: Never open both valves on the two-color gun at
the same time. Paint color contamination could result.
14. Place empty pail under spray guns to catch
drainage from spray guns.
15. Turn guns on with Programmable Skipline
Controller.
16. Turn the bypass valve to RUN (closed), and open
hydraulic valve(s) to activate pumps.
17. When water/solvent comes out of spray gun(s), set
paint pump hydraulic valve(s) to OFF position.
18. Turn off guns with Programmable Skipline
Controller.
19. Shut off engine and Programmable Skipline Control-
ler.
20. Leave paint pump prime/spray valve(s) and spray
gun ball valve(s) open.
21. Remove and secure ground strap from earth
ground.
To Next Page
Loading...
