Operation
3A5384B 23
5. Close paint gun ball valves.
6. Open all drain valves, one at a time.
7. Close valves immediately to prevent paint from dry-
ing in system.
8. If you suspect the spray tip or hose is clogged or
that pressure has not been fully relieved:
a. VERY SLOWLY loosen the tip guard retaining
nut or the hose end coupling and relieve pres-
sure gradually.
b. Loosen the nut or the coupling completely.
c. Clear the obstruction in the hose or tip.
Bead System Pressure Relief
1. Relieve air pressure in bead tank by turning bead
system valve to OFF position.
Air System Pressure Relief and
Condensation Drain
1. Relieve air pressure and drain condensation in air
tank by turning air valve to OPEN position.
EMERGENCY SHUT OFF
To shut down the entire RoadLazer system, set
POWER ON/OFF on the Programmable Skipline Con-
troller to the OFF position.
Load Reflecting Materials
1. Set POWER ON/OFF on Programmable Skipline
Controller to OFF.
2. Set RoadLazer engine ignition key to OFF.
3. Relieve air system pressure by opening ball valve
on the air tank until gauge reads 0.
4. Relieve air pressure in bead tank by turning bead
system valve to OFF position.
5. Remove cover from bead tank.
6. Screen reflective materials to prevent debris from
entering tank.
7. Turn T-handle counterclockwise to open bead fill
port.
8. Load bead tank with reflective materials.
9. Once filled, turn T-handle clockwise, and place
cover on tank.
To Next Page
Loading...
