Setup
3A5384B 21
Install Front Pointer Instructions
1. Locate an area on the vehicle to mount the Road-
Pak pointer system that will allow the user to see the
indicator rod from the driving position or with the
help of the Road View Camera System.
2. If needed, drill two 9/16 in. holes in the desired loca-
tion.
3. Assemble mounting bracket (355) to desired loca-
tion with bolt (359), washer (360), and nut (361).
4. Hand tighten lock bar (356) to mounting bracket
(355) with bolts (357) and nuts (358).
5. Slide support bar (351) through brackets (355) and
tighten fasteners to secure in place.
6. Assemble extension clamp to support bar.
7. Insert indicator rod (362) into guide extension arm
(352) and secure in place with knob (354).
8. Adjust the indicator rod by loosening extension
clamps and sliding the guide extension arm (352) to
desired position. Secure by tightening knob (354).
Kits (Optional)
Refer to the kit manuals for installation and usage.
• Front Guidance System
• Video Guidance System
• Winch Kit
•Seat Kit
• Additional Gun Kit
• Laser Kit
• Steerable Carriage Kit
• Pressure Balance Kit
• Double Drop Kit
To Next Page
Loading...
