Introduction and General Information
3A5384B 7
Introduction and General Information
Introduction
This manual and those listed below provide pre-setup require-
ments, parts lists, setup, operation, and maintenance instruc-
tions for the RoadLazer, RoadPak and RoadPak HD systems.
This manual includes instructions for a 2-pump system. For
1-pump systems, all parts remain the same with the exception
of plugged ports for missing pumps and hoses.
General Information
The RoadLazer is mounted to a vehicle and is used to stripe
up to five stripes in one or two colors with glass beading.
The RoadLazer RoadPak consists of a Programmable Skipline
Controller, Displacement Pumps, two Paint Spray Guns, and
two Bead Spray Guns. The RoadPak HD is provided with
three paint spray guns, and three bead spray guns.
Programmable Skipline Controller
The Programmable Skipline Controller consists of the control
box and a 30 ft cable. It is the main control for the RoadLazer
system and turns the spray guns and accessories on and off.
RPS 2900 Hydraulic Pumps
The RPS 2900 Hydraulic Pump supplies paint to the spray
guns. There are two displacement pumps. Two displacement
pumps allows the user to have a two-color system.
Paint Spray Guns
The Paint Spray Guns are pneumatically triggered to spray
paint stripes when commanded by the Programmable Skipline
Controller.
Bead Spray Guns
The Bead Spray Guns are pneumatically triggered to spray
reflective materials when commanded by the Programmable
Skipline Controller.
Optional Accessory Kits
Winch Kit
The RoadPak Winch Kit is used to lift the gun arm during spray
operation.
Seat Kit
The Seat Kit allows for an operator position to be added to the
bed of the vehicle. This allows for better control of the guns
and steerable carriage.
Additional Gun Kit
The Additional Gun Kit consists of one bead gun and one
spray gun, and the needed fittings, hoses, air tubing and
mounting hardware to add the guns to the gun arm carriage.
Laser Kit
The Laser Kit provides the user with a bright green line to fol-
low for vehicle and spray gun alignment.
Steerable Carriage Kit
The Steerable Carriage is fitted to the existing gun arm car-
riage, which gives the operator the ability to drive the carriage
left or right at a chosen speed. The control can be mounted to
the Seat Kit control arm, or used as a hand-held control.
Pressure Balancing Kit
The Pressure Balancing Kit allows the operator to connect the
two paint pumps at their outlets to balance the pressure
between the two pumps. This ensures that each spray pattern
is equal at each gun.
Double Drop Kit
The Double Drop Kit consists of one bead gun, one bead
hose, and the fittings to connect the parts. It is used for ele-
ment double drop applications.
Video Guidance System
™
The video Guidance System provides the user with video of a
bore sight view for alignment on either the left or right side of
the vehicle. The system consists of a 9 in. monitor, interfacing
cables, video camera and mounting bracket.
Front Guidance System
The Front Mechanical Guidance System provides the user
with a pointer for alignment on either the left or right side of the
vehicle.
To Next Page
Loading...
