Operation
22 3A5384B
Operation
Grounding Procedure
(For Flammable Materials Only)
1. Ground RoadLazer with grounding clamp to earth
ground during flushing.
Pressure Relief Procedure
Follow the Pressure Relief Procedure when-
ever you see this symbol.
RPS 2900 Pump Fluid Pressure Relief
1. Set hydraulic valve to OFF position.
2. Run engine at half throttle.
3. Place empty pail under paint guns to catch drain-
age.
4. Relieve hose pressure through guns. Use Program-
mable Skipline Controller to trigger each gun for at
least 3 seconds each.
The equipment must be grounded to reduce the risk
of static sparking. Static sparking can cause fumes to
ignite or explode. Grounding provides an escape wire
for the electric current.
This equipment stays pressurized until pressure is
manually relieved. To help prevent serious injury
from pressurized fluid, such as skin injection, splash-
ing fluid and moving parts, follow Pressure Relief
Procedure when you stop spraying and before clean-
ing, checking, or servicing the equipment.
NOTICE
Always relieve pressure with the guns, not with the fil-
ter drain valves. Using the filter drain valves can
cause damage, and prevent them from sealing in the
close/spray positions.
To Next Page
Loading...
