Operation
3A5384B 27
4. Place suction hoses in paint drums.
5. Open hydraulic valve(s) to activate pumps.
6. When paint comes out of return lines, set hydraulic
valve to OFF position.
7. Turn all drain valves to the SPRAY (closed) posi-
tion.
8. Place return lines into paint drum.
Prime Guns
1. Close air valve to pressurize air system.
2. Only open the spray gun ball valves corresponding
to paint pumps and/or color to be used.
NOTE: Never open both ball valves on the two-color
gun at the same time. Paint color contamination could
result.
3. Place an empty pail under spray guns to catch
drainage from spray guns.
4. Turn guns on with Programmable Skipline Control-
ler (see Skipline Controller manual).
5. Open hydraulic valve(s) to activate pumps.
6. Turn off guns with Programmable Skipline Control-
ler.
To Next Page
Loading...
