Setup
3A5384B 19
Hose Routing
1. Pull slide beam out to one side of the vehicle. Pull
gun arm out and lower it to make sure the hose bun-
dle has been secured at the proper location to
ensure full movement for the gun arm to move from
one side to the other. Make adjustments to the hose
clamp that secures the bundle as needed.
2. Lift gun arm back to the stow position. Pull slide
beam out to other side of vehicle and pull the gun
arm to that side to ensure the hose length is ade-
quate for full movement.
3. Put gun arm back to the stow position and pin it into
place. Center the slide beam to the vehicle. Lock
the slide beam and gun arm into place by engaging
the clamps for each.
Hose Connection
1. Install suction tubes to the RPS 2900 pump and
route to paint drum or tote.
2. Install return line from the RPS 2900 filter assembly
and route back to the paint drum or tote.
3. Install paint lines to RPS 2900 filter assemblies. For
a two color system, route the hose from paint gun 1
to pump 1 and route one hose from paint gun 2 to
pump 1. Route the second hose from paint gun 2 to
pump 2.
To Next Page
Loading...
