Section 3 - Operation
3-182104002
SECTION 3 - OPERATION
3.1 REMOTE CONTROL PREPARATION
Preparing Undercarriage for Remote Control Operation
Remote travel is to be used for positioning unit at job site, not for over-the-road
driving. After reaching job site, perform the following steps to prepare undercarriage
for remote control operation:
1. Park the machine in a safe, level area.
2. Turn undercarriage ignition switch to “OFF” position.
3. Set the undercarriage park brake.
4. Set Travel/Remote selector switch, located on undercarriage cab dash, to
remote
5. Proceed to upperstructure cab.
TRAVEL
REMOTE
OAC2290
To Next Page
Loading...
