Section 3 - Operation
3-22 82104002
3.9 RETURN TO TRAVEL MODE
Preparing Upperstructure for Undercarriage Operation
1. Position unit on level surface and release travel pedal to neutral position to
engage digging brake.
2. Position boom in rest, allowing clearance for attachment. See “Boom Stow
Procedure” on page 3-23.
3. Apply parking brake.
4. Shut down engine from upperstructure cab.
5. Proceed to undercarriage cab.
6. Set parking brake in undercarriage cab.
7. Set Travel/Remote selector switch, located on chassis cab dash, to travel.
8. Start engine.
TRAVEL
REMOTE
OAC2290
To Next Page
Loading...
