33
DE
EN
FR
NL
IT
ES
DK
NO
SE
PL
HU
UKR
ments have to be met during the electrical connection:
- Before connecting the unit, compare the connecting data (voltage
and frequency) on the type plate with those of your energy net-
work. These details must correspond so that no damage occurs to
the unit. In case of doubt ask your trained electrician.
- The socket has to be protected at least by a 10 amps circuit
breaker.
- Make sure that the power cable is not damaged and is not laid
across hot surfaces or sharp edges.
- The connecting cable must not be stretched tightly.
- The electric safety of the unit is ensured only when it is connected
to a socket with protective conductor installed correctly. Oper-
ation on a socket without protective conductor is forbidden. If in
doubt, let the house installation checked by a trained electrician.
The manufacturer shall not assume responsibility for damage
which has been caused by absent or interrupted protective con-
ductor.
To Next Page
Loading...
