Graef SKS 700 - Page 47

47
DE
EN
FR
NL
IT
ES
DK
NO
SE
PL
HU
UKR
Problem Cause Solution
The stop illumination
lights red
Safety instruction - the
stop stands open for a
long time
Check to see that the
stop is completely
closed after using the
machine. The stop illu-
mination goes out.
The stop illumination
pulsates red and the il-
lumination of the blade
and the scaler go out
Safety instruction - the
stop has already stood
open for a long time
Check to see that the
stop is completely
closed after using the
machine. The stop illu-
mination goes out.
The unit slips on the
work top while cutting
The installation surface
or the rubber feet of
the unit are soiled
Make sure that the
installation surface
and the rubber feet of
the machine are clean
and free from grease.
Select a suitable
installation surface, if
necessary
Blade blocks while
cutting
The unit is overloaded Interrupt the cutting
process and cautious-
ly remove the slicing
material. Make sure
to use only suitable
goods to be cut and
adjust the cut width ac-
cordingly, if necessary.
The connection line
cannot be pushed into
the cable compartment
The connection line is
blocked in the cable
compartment
Pull the connection line
a bit out of the cable
compartment and
push it in again. While
doing so, check to see
that a short length as
possible of the con-
nection line is grasped.