Graflex 35 - img006

6. Be sure film is winding straight, if not,
move it up or down on the take-up reel
until it will wind straight. Place back
over the film and slide it into the closed
position. Lock QY turning locking lever
clockwise, as far as it will go as shown.
IMPORTANT - Repeat steps 4 and 5 twice turning the winding knob as far as it will
go each time. The film is now positioned and ready for the first exposure.
Note : Unless the self-timer (page 8) is to be used be sure the synchro-setting lever on
the side of the shutter is at " M" or "X" for general daylight use. For flash settings
see pages 20 and 21.
7. Set exposure counter at "20" for 20-exposure films and at "0" for 36-exposure films.
To set, press down on the center of the dial and turn. After each exposure, turn the
film winding knob until it locks; the
exposure counter dial will automati-
cally turn one full revolution plus one
space and will tell you how many
exposures you have left.