Call Waiting
This feature will notify you of a new incoming call during an established call and display the incoming call information visually
on the LCD screen and a call waiting tone will be heard. If this feature is disabled, the new incoming call will be automatically
rejected.
There are 2 ways to activate call waiting feature either using DP722/DP730 Handsets Menu or using DP755 Base Station Web
Interface.
Using DP722/DP730 Handsets Menu
1. Press Menu to bring up operation menu.
2.
Use arrow keys to reach Call Features 🡪 navigate to Call waiting sub-menu.
3. Select the account for which you want to enable the Call waiting feature, and then press left softkey “Select”.
4. Choose between Enabled and Disabled options and press the softkey “Save”, a prompt message will be displayed to
confirm that the call waiting is enabled / disabled.
5.
During an established call, press (dial key) to put first call on hold and answers second incoming call. If no
second incoming call, pressing will give the ability to initiate another call while first one is on hold.
Using DP755 Base Station Web Interface
1. Access DP755 Base Station Web Interface.
2. Go to DECT 🡪 Handsets Settings 🡪 HS# Settings.
3. Set “Disable Call Waiting Tone” to “No”. (Default is No).
4. Press “Save and Apply” button to confirm.
Do Not Disturb
You can activate or deactivate the DND mode for your accounts registered on the handsets under the call settings. If DND
mode is activated for a specific line, all incoming calls will receive busy treatment depending on your configuration (forward
to voice mail, busy tone…)
To enable or disable the DND mode, follow the next steps
1. Press Menu to bring up operation menu.
2.
Use arrow keys to reach Call Features 🡪 navigate to Do Not Disturb sub-menu.
3. Select the account on which you want to enable / disable the DND mode and then press “Select”
4. Choose between Enabled and Disabled options and press softkey “Save” to accept the changes, a prompt message will
be displayed to confirm that the DND is enabled / disabled.
You can navigate to Status 🡪 Line status to check if the DND mode is enabled on the base station.
You can also navigate via web interface of DP755 🡪 Status 🡪 Line Options.
Call Forward
The call forward feature will allow you to forward all the incoming calls to the desired number. Three possible call forward
types are available on the DP722/DP730.
Forward all Dest: All the incoming calls are immediately forwarded.
Note
You can switch between active/on-hold calls by pressing Options 🡪 Swap.
To Next Page
Loading...
Need help?
General