Grandstream Networks HT812 Administration Guide

P a g e | 21
HT812/HT814 Administration Guide
Version 1.0.9.3
02
“IP Address “ + IP address
The current WAN IP address is announced
If using “Static IP Mode”, enter 12-digit new IP address.
You need to reboot your HT812/HT814 for the new
IP address to take Effect.
03
“Subnet “ + IP address
Same as menu 02
04
“Gateway “ + IP address
Same as menu 02
05
“DNS Server “ + IP address
Same as menu 02
07
Preferred Vocoder
Press “9” to move to the next selection in the list:
 PCM U / PCM A
 iLBC
 G-726
 G-723
 G-729
 OPUS
10
“MAC Address”
Announces the MAC address of the unit.
Note: The device has two MAC addresses. One for the
WAN port and one for the LAN port. The device MAC
address announced is the address of LAN port.
12
WAN Port Web Access
Press “9” to toggle between enable / disable.
Default is disabled.
13
Firmware Server IP Address
Announces current Firmware Server IP address.
Enter 12-digit new IP address.
14
Configuration Server IP
Address
Announces current Config Server Path IP address.
Enter 12-digit new IP address.
15
Upgrade Protocol
Upgrade protocol for firmware and configuration update.
Press “9” to toggle between TFTP / HTTP / FTP / FTPS
or HTTPS.
Default is HTTPS.
16
Firmware Version
Announces Firmware version information.
17
Firmware Upgrade
Firmware upgrade mode. Press “9” to toggle among the
following three options:
 Always check
 Check when pre/suffix changes
 Never upgrade

Grandstream Networks HT812 Specifications

General

Brand	Grandstream Networks
Model	HT812
Category	Telephone Accessories
Language	English