To Next Page

To Previous Page

P a g e | 9

HT812/HT814 Administration Guide

Version 1.0.9.3

 Added feature “Internet Protocol” to choose from “IPv4 Only”, “IPv6 Only”, “Both, prefer IPv4”, “Both,

prefer IPv6”. [Internet Protocol]

 Added feature “IPv6 Address” to configure IPv6 Address. [IPv6 Address]

Firmware Version 1.0.3.7

 Added option “Use Actual Ephemeral Port in Contact with TCP/TLS” to force device to use actual

ephemeral port. [Use Actual Ephemeral Port in Contact with TCP/TLS]

 Added option “SIP URI Scheme When Using TLS” to choose between ‘SIP’ and ‘SIPS’. [SIP URI

Scheme When Using TLS]

 Added Option “Backup Outbound Proxy” to use backup Outbound Proxy if Outbound Proxy registration

expires. [Backup Outbound Proxy]

 Added option “Prefer Primary Outbound Proxy” to enable registration through primary outbound proxy

if registration expires. [Prefer Primary Outbound Proxy]

 Added option “Enable RTCP” to enable RTCP function through Web UI. [Enable RTCP]

 Added option “Hold Target Before Refer” to enable device to hold before being referred. [Hold Target

Before Refer]

 Added Option “Enable Session Timer” to disable session timer. [Enable Session Timer]

 Added feature “Conference URI” to support Conference URI. [Conference URI]

 Added feature “White List for WAN Side” for remote management. [White List for WAN Side]

 Added feature “Black List for WAN Side” for remote management. [Black List for WAN Side]

 Added option “Web Access Mode” to choose between “HTTPS” and “HTTP” to access device Web UI.

[Web Access Mode]

 Added feature “HTTPS Web Port” to set HTTPS web port instead of using default HTTPS port. [HTTPS

Web Port]

 Added feature “SSH Port” to self-configure SSH port. [SSH Port]

 Added SNMP related features.

Firmware Version 1.0.3.2

 Added option “DNS SRV use Registered IP” to force DNS SRV to use registered IP instead of use first

SRV. [DNS SRV use Registered IP]

 Changed default NTP server from us.pool.ntp to pool.ntp.org.

Firmware Version 1.0.2.7

 No major changes

Firmware Version 1.0.2.5

 Changed OPUS Payload Type default value to 123 to match other GS products. [OPUS Payload Type]

Grandstream Networks HT812 Administration Guide

Other manuals for Grandstream Networks HT812