5. Confirm the new end-user password.
6. Press Apply at the bottom of the page to save your new settings.
Figure 6: User Level Password
Changing HTTP Web Port
1. Access your HT818 web UI by entering its IP address in your favorite browser.
2. Enter your admin password (default: admin).
3. Press Login to access your settings.
4. Go to Basic Settings → HTTP Web Port.
5. Make sure that the Web Access Mode is set to HTTP.
6. Change the current port to your desired/new HTTP port. Ports accepted are in range [1-65535].
7. Press Apply at the bottom of the page to save your new settings
Figure 7: Web HTTP Port
Web Configuration Pages Definitions
This section describes the options in the HT818 Web UI. As mentioned, you can log in as an administrator
or an end user.
• Status: Displays the system info, network status, account status, and line options.
• Basic Settings: Configures the end user level password, IP address modes, web access, time zone
settings and language.
• Advanced Settings: Configures networks, upgrading and provisioning, TR-069, security settings,
date and time, syslog, audio settings, call settings and call progress tones.
• Profile (1, 2): Configures the SIP Server, SIP Registration, NAT settings, call features, ring tones.
To Next Page
Loading...
Need help?
General
