HT818 Administration Guide
Version 1.0.27.2
Advanced Settings Page Definitions
Table 8: Advanced Settings
Defines the administrator level password to access the Advanced Web
Configuration page.
This field is case sensitive. Only the administrator can configure the “Advanced
Settings” page. Password field is purposely left blank for security reasons after
clicking update and saved.
The maximum password length is 30 characters.
Re-enter the admin password to confirm change admin password on web GUI to
avoid typo or mistakes.
Disable User Level Web
Access
Allows admin user to enable/disable User Level web access. when set to “Yes”,
user level web access will be disabled.
Default settings is “No”
Disable Viewer Level
Web Access
Allows admin user to enable/disable Viewer Level web access. when set to “Yes”,
viewer level web access will be disabled.
Default settings is “No”
Sets values for:
802.1Q/VLAN Tag. Default is 0. Valid range is 0-4094.
SIP 802.1p. Default is 0. Valid range is 0-7.
RTP 802.1p. Default is 0. Valid range is 0-7.
Black List for WAN Side
Port
It could be either port range or single port separated by a “,”
Example: “5000-6000, 7000 “.
Configures IP address or domain name of STUN server. Only non-symmetric NAT
routers work with STUN.
Sends periodically a blank UDP packet to SIP server in order to keep the "ping
hole" on the NAT router open. Default is 20 seconds.
Use STUN to detect
network connectivity
Uses STUN keep-alive to detect WAN side network problems. If keep-alive request
does not yield any response for configured number of times (minimum 3), the
device will restart the TCP/IP stack. If the STUN server does not respond when
the device boots up, the feature is disabled. Default setting is No.
Uses DNS to detect WAN side network problems.
To Next Page
Loading...
Need help?
General
