Grandstream Networks HT818 Administration Guide

P a g e | 48
HT818 Administration Guide
Version 1.0.27.2
Authenticate server
certificate chain
Configures whether to validate the server certificate when download the
firmware/config file. If it is set to "Yes", the phone will download the firmware/config
file only from the legitimate server. The default setting is "No".
Allow Incoming SIP
Messages from SIP
Proxy Only
Checks SIP address of the Request URI in the incoming SIP message; if it doesn't
match the SIP server address of the account, the call will be rejected.
Default is No.
Use Privacy Header
Determines if the “Privacy header” will be presented in the SIP INVITE message
and if it includes the caller info in this header. If set to Default, it will add Privacy
header unless special feature is Telkom SA or CBCOM. Default is Default.
Use P-Preferred-Identity
Header
Specifies if the P-Preferred-Identity Header will be presented in the SIP INVITE
message. If set to “default", the P-Preferred-Identity Header will be omitted in SIP
INVITE message when Telkom SA or CBCOM is active. If set to "Yes", the P-
Preferred- Identity Header will always be presented. If set to "No", it will be omitted.
Default setting is: Default.
Use P-Access-Network-
Info Header
With this feature enabled, device will populate the WAN access node with IEE-
802.11a, IEE-802.11b in P-Access-Network-Info SIP header.
Use P-Emergency-Info
Header
This feature support of IEEE-48-addr and IEEE-EUI-64 in SIP header for emergency
calls.
Use P-Asserted-Identity
Header
When this feature is set to Yes, device will send P-Asserted-Identity Header on the
SIP Invite.
SIP REGISTER Contact
Header Uses
Specifies which address (LAN or WAN address) the device will detect to use it in
SIP Register Contact Header.
Default is LAN Address.
Caller ID Fetch Order
Selects the Caller ID display order which need to be respected by the HT818. The
available options are:
• Auto: When set to “Auto”, the HT818 will look for the caller ID in the order
of P-Asserted Identity Header, Remote-Party-ID Header and From Header
in the incoming SIP INVITE.
• Disabled: When set to "Disabled", all incoming calls are displayed with
"Unavailable".
• From Header: When set to “From Header”, the HT818 will use the FROM
header to display the caller ID.
Allow SIP Factory Reset
Allows to reset the devices directly through SIP Notify. If “Allow SIP Factory Reset”
is set to “YES” under Profile page, then the ATA receives the NOTIFY from the SIP

Grandstream Networks HT818 Specifications

General

Brand	Grandstream Networks
Model	HT818
Category	Telephone Accessories
Language	English