HT818 Administration Guide
Version 1.0.27.2
Note: If server supports Alert-Info header and standard ring tone set (Bellcore) or
distinctive ring tone 1-10 is specified, then the ring tone in the Alert-Info header
from server will be used. Bellcore rings and tones are independent from custom
ring tones. The custom ring tones can also be specified by alert-info header, for
example Alert-Info: ;info=ring5
Chooses between RFC2543 hold and RFC3261 hold. Select Yes for RFC2543
hold, No for RFC3261 hold. Default is Yes.
Disables receiving a second incoming call when the line is engaged.
Default is No.
Disable Call Waiting
Caller ID
Disables displaying caller ID when receiving a second incoming call.
Default is No.
Disable Call Waiting
Tone
Disables playing call waiting tone during active call when receiving a second
incoming call. The CWCID will still be displayed. Default is No.
Disable Connected Line
ID
Disables displaying the number of the person answering the phone.
Default is No.
Disable Receiver Off
hook Tone
Enables / disables the warning to alert that the phone has been left off-hook for an
extended period of time.
Default is No.
Disable Reminder Ring
for On-Hold Call
Enables playing the reminder ring. Default is No
Disable Reminder Ring
for DND
This feature allows user to disable reminder ring when FXS port is on DND
mode. Default is No
Disables use of visual message waiting indicator when there is an unread
voicemail message. Default is No.
Configures Visual WMI Type of signal sent to the analog phone to make it turn the
lamp ON upon receiving a Voice mail.
Check the phone’s manual to find out what signal is supported, FSK (default) or
NEON.
Note: Some phones (depends on the model of the analog phone) when this feature
is set to NEON it might auto ring (short beeps) when there is a voice mail available
for that FXS port where it is connected.
Do Not Escape '#'
as %23 in SIP URI
Replaces # by %23 in some special situations. Default is No.
To Next Page
Loading...
Need help?
General
